A multi-axial electromagnetically actuated punch for cutting micro-components
- authored by
- Matthias Dagen, Mauro H. Riva, Bodo Heimann, Tobias Ortmaier, Christian Wager, Richard Krimm, Bernd Arno Behrens
- Abstract
In this paper a multi-axial electromagnetically actuated punch is presented. This punch can apply forces up to 60kN and has a maximum stroke of 4mm. Especially, the punch is qualified for manufacturing micro-components demanding high accuracy and high stroke rates. Due to its multi-axial drive concept, the punch is able to compensate the tilt of the ram during the cutting process. Thus, abrasion at the die is reduced and the punching quality is improved. Therefore, two multiaxial control concepts are introduced and compared based on experimental results.
- Organisation(s)
-
Institute of Mechatronic Systems
Institute of Metal Forming and Metal Forming Machines
- Type
- Conference contribution
- Pages
- 4570-4575
- No. of pages
- 6
- Publication date
- 26.11.2012
- Publication status
- Published
- Peer reviewed
- Yes
- ASJC Scopus subject areas
- Electrical and Electronic Engineering
-
Details in the research portal "Research@Leibniz University"
